Jaguar/Jazzmaster [Won't Fall Out] Arm Height Adjustment Insert

This is an insert for adjusting the height of the arm on Jaguar/Jazzmaster floating tremolos.

Recommended for those who want to set the arm position higher.
After installation, the arm is held by the strong magnetic force of neodymium, so it will not come off even if the guitar is turned upside down.

Installation Method
Remove the tremolo block from the guitar and insert the neodymium from behind the arm holder (refer to the product photos).
The height of the arm will be determined by how far you insert the neodymium, so adjust it to your preferred position.
Once the position is set, tighten it with the included tight lock and reassemble.

The height can be set from approximately 27mm or more from the tremolo block to the arm.

Compatible with pop-in type Jaguar and Jazzmaster floating tremolos such as Fender Japan, and those with a 5mm arm diameter.
Although registered under the Fender brand, it is compatible with other manufacturers if the arm diameter is 5mm and made of iron.

Notes
The arm holder in the photo is for reference only. It is not included.
The product includes 1 neodymium and 2 tight locks as shown in the third photo.

Tapping the neodymium with a hammer or similar tool can cause damage. Please gently insert it after slightly widening the opening of the arm holder.

There have been serious accidents where children have swallowed neodymium, requiring abdominal surgery.
This product is not intended for use by children, and should be handled by individuals aged 14 and above.